|
|
输送机的故障处理 Fault handling of conveyor※跑偏的原因有多种，需根据不同的原因区别处理。 第 一 ： 调整承载托辊组 第 二 ：安装调心托辊组 第 三 ：张紧处的调整 皮带张紧处的调整是皮带输送机跑偏调整的一个 非常 重要的环节。 第 四 ：调整驱动滚筒与改向滚筒位置 驱动滚筒与改向滚筒的调整是皮 带跑 偏调整的重要环节 第 五 ：双向运行皮带输送机跑偏的调整 ※皮带打滑的处理办法： 第 一 ：螺旋张紧或液压张紧皮带机的打滑使用螺旋张紧或液压张紧的皮 带 输送机出现打滑时可调整张紧行程来增.大张紧力。但是，有时张紧 行 程已不够，皮带出现了永.久性变形，这时可将皮带截去一段重新进 行 硫化。 第 二 ：在使用尼龙带或EP是要求张紧行程较长，当行程不够时也可重新 硫 化或加大张紧行程来解决。 ※ there are many reasons for deviation, which should be handled differently according to different reasons. First: adjust the bearing idler group Second: install the self-aligning idler group Third: adjustment of belt tension adjustment of belt tension is a very important link of belt conveyor deviation adjustment. Fourth: adjust the position of the driving drum and the reversing drum. The adjustment of the driving drum and the reversing drum is an important link in the belt deviation adjustment Fifth: adjustment of deviation of two-way running belt conveyor ※ handling method of belt slip: First: slip of spiral tensioned or hydraulic tensioned belt conveyor. In case of slip of spiral tensioned or hydraulic tensioned belt conveyor, the tensioning stroke can be adjusted to increase High tension. However, sometimes the tensioning stroke is not enough and the belt appears permanent In case of permanent deformation, a section of the belt can be cut off and vulcanized again. Second: when using nylon belt or EP, the tensioning stroke is required to be long. When the stroke is not enough, it can also be re vulcanized or increased. Third: the belt slip of the heavy hammer tensioning belt conveyor. The belt conveyor with the heavy hammer tensioning device can add a counterweight to solve the belt slip until the belt does not slip. However, too much should not be added, so as not to make the belt bear unnecessary excessive tension and reduce the service life of the belt. |
